Materia Collection 3.0 instructions

INSTRUCTIONS below!

Read carefully before continuing with the instructions.

About the MATERIA BRACELET (1) 3.0:
You don't need to apply too much force to put this bracelet on, although the adjustable clasp may feel a little hard. Try not to pull it with too much force or the knot on the opposite end of the bracelet from where you're pulling may come loose, even though it's tight!
Please note: There is only one way to put the bracelet on correctly, and it is described in the instructions. Sticky Shell will no longer refund or replace the bracelet if the customer improvises and breaks it by trying to close it the incorrect way, using more force than necessary.

About the MATERIA SLOT (1) 3.0:
It is normal for the back of the Slot to wear out or get scratched over time, so don't worry.
It is highly recommended (if not mandatory) to use the metal pick (or any hard flat surface in place of the metal pick) to detach the Slot from the bracelet.
Trying to remove a Slot from the bracelet with bare hands may damage the bracelet itself. 
Sticky Shell will not refund or replace the item should the above occur.

About the metal pick keychain:
It is normal for the metal pick to slightly bend over long time from using it to detach a Slot from the bracelet.

 

INSTRUCTIONS

How to wear a Materia Bracelet (1) 3.0:
Simply do the following: open the bracelet to its maximum extension. Put it on by turning the wrist and knot of the clasp upward. Hold the longer lace with the two fingers of the same hand and finally pull the shorter lace in the opposite direction of the longer lace. By doing so, the bracelet will close easily without stressing the knots.
Please note: There is only one way to put the bracelet on correctly, and it is described in the instructions. Sticky Shell will no longer refund or replace the bracelet if the customer improvises and breaks it by trying to close it the incorrect way, using more force than necessary.

How to equip a Materia Slot (1) 3.0:
Slip the Slot into the seat at an angle by pressing against one of the two slats so that, as it retracts, it allows the Slot to enter. Then press downward to safely secure it on the bracelet.

How to unequip a Materia Slot (1) 3.0:
Perform this operation when you are not wearing the bracelet. Hold the bracelet, keep your thumb on the Slot to prevent it from popping off, and then insert the pick under the Slot as far as it will go. Gently pry it toward you until the Slot pops out. If you feel excessive resistance, rotate the bracelet by 180 degrees and repeat the operation. Sometimes this operation is only successful on one side!

 

< Back to Materia Collection 3.0